LG LTCS24223 Serie Manual De Instrucciones página 7

WARNING
EXCESSIVE WEIGHT HAZARD
Use the assistance of two or more persons to move or
install the refrigerator. Not following these instructions
may cause injury to the back and other parts of the
body.
UNPACKING
Before installing your refrigerator, remove any tape
or temporary stickers. Do not remove any stickers
that feature warnings, the model serial number or the
technical label of the product located on the back of the
refrigerator.
NOTE: Remove protective film on doors before plugging
in the unit (on some models).
To remove adhesive tape residue, rub it well with your
fingers and a little liquid detergent. Clean with warm
water and let dry.
Do not use sharp instruments, rubbing alcohol, flammable
liquids or abrasive cleaning products to remove the
adhesive tape or glue. These products can damage the
surface of your refrigerator. For more information, see
the section on "Impo rtant Safety Instructions".
The shelves come already installed in their factory
position. Remove the shelves and replace them
according to your spacing needs.
Moving Your Refrigerator:
Your refrigerator is extremely heavy. Make sure you
protect the floor when moving your refrigerator for
cleaning or servicing. Always pull your refrigerator
straight out when moving it. Do not shift from side
to side or "walk" the refrigerator when attempting to
move it as this can cause damage to the floor.
WARNING
EXPLOSION HAZARD
Keep all flammable materials and vapors (such as
gasoline) away from the refrigerator. Not following
these instructions may cause death, explosion or fire
CAUTION:
This appliance is intended to be used in household and
similar applications such as: staff kitchen areas in shops,
offices and other working environments; farm houses
and by clients in hotels, motels and other residential type
environments, bed and breakfast type environments,
catering and similar non-retail applications.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
INSTALLATION
1. Avoid placing the unit near heat sources, direct
sunlight, or humidity.
2. To avoid vibration, the unit should be leveled and
placed on even floor. If needed, adjust the leveling
screws to compensate for an unleveled floor. The front
should be slightly taller than the rear to ensure that the
doors close properly. The leveling screws can easily be
turned by slightly tilting the front of the refrigerator,
turning the leveling screws clockwise (
and counter-clockwise (
Install the refrigerator in an area between 55 °F (13 °C)
3.
and 110 °F (43 °C). If the surrounding temperature is
lower or higher than previously mentioned, it can
adversely affect the unit.
ONCE INSTALLED
1. Carefully clean your refrigerator and remove and dust
accumulated during shipping.
2. Install accessories such as the ice bin, door racks,
shelves, etc., in their proper places. These are already
packed to prevent any possible damage during
shipping.
3. Leave your refrigerator on for 2 to 3 hours before
storing food inside. Verify that there is a flow of cold air
in the freezer compartment to ensure proper cooling.
Your refrigerator is now ready for use.
Take care when working with the hinges, base cover
and stops, etc. You may injure yourself.
DO not place your hands or any tools in the air vents,
the base cover or in the bottom of the refrigerator. This
may cause injury or electrical shock.
Keep a Proper Distance from Adjacent Objects
Please keep the refrigerator at an adequate distance
from other objects. Insufficient spacing can reduce the
refrigerator's freezing efficiency and increase electricity
consumption.
5
CAUTION:
Avoid placing the unit near heat
sources, direct sunlight or humidity.
WARNING:
2" (5.08 cm)
2" (5.08 cm)
2" (5.08 cm)
) to raise it
) to lower it.
2" (5.08 cm)