Kenmore 758.144161 Manual Del Usuario página 13

Troub/eshoodng
Trouble Probable Cause Remedy
Unit will nst run. • SsIsctsd humidity level has , Raise humidistat setting if
been established, dssired.
• No Power. _ Check 120 volt source fsr
power.
Unit will nst shut off. • Float retainer is positioned in _ Slids link arm asssmbly
"Manual Drysut" position, rstainer ts lowest positisn in
slot at back sf cabinet. (See
page 7).
• Float is not free. _ Free float from obstruction.
Unit will nst dry out completely. • A small amount of watsr _ Position float assembly in
remains in cabinst when "Manual Drysut" position.
water level indicator reads (Sss page 7).
FILL.
Unit is not emptying during • Dirty filters. , Change ts fresh nsw filters.
USS,
Water runts out of rear of unit.
Water IsvsI gauge not
functioning properly.
Water splashing during filling.
Filters interfsring with float.
Deflect fill water off ths center
of ths splash guard.
Do not ovsrfill past "Full" label
in cabinet.
Be sure filtsrs ars positisnsd
properly in bottom of cabinet.
(Sss page 9).
CAUTION: Uss only 32-14900 EPA Rsgistsrsd Bacteriostat availabIs from Sears Rstail store.
Uss of other water treatment products may damage ths filter sIsmsnts.
Under no circumstances shsuld ysu use water treatment products designed for Rata belt sr
Ultrasonic humidifiers.
13