Kenmore 758.144161 Manual Del Usuario página 8

Using Your Humidifier
Step 1 :
Be sure humidifier is fuil of water and
plugged in.
Step 2:
Set Speed Control " _ " to lowest
speed ",,".
Step 3: @
Set Humidity Control .... to medium
position.
NOTE: Humidifier should operate with
humidity control on the recommended
medium setting, if it does not, the
humidity is at a relatively high IeveI.
To test the unit under this condition, turn
Humidity Control all the way to clockwise
and unit should begin to operate. After
the unit has been tested, set Humidity
Controi to medium or desired Ievel.
Ailow 24 hours for humidifier to adjust.
if humidity IeveI in home is sufficient, the
humidifier will only operate with Humidity
Control turned all the way clockwise.
tr-aPORTANT: Water damage may result
if condensation starts to form on windows
or walls. Humidity Controt setting should
be lowered until condensation no longer
forms.
Step 4:
if humidifier stops running and the unit is
not empty, the humidity leve! is at the
normal requirements for that setting or it
is adjusting to the home conditions. The
table below shows recommended indoor
humidity Ievets. The figure shows
approximate relative humidity
percentages which correspond to the
various settings of the Humidity Control.
When Outdoor Recommended Indoor
Temperature is: Relative Humidity is:
-10°F 20%
0°F 25%
10 ° F 30%
20°F 35%
Operating Tips for Best Performance
1. Position the humidifier at least 2 inches
from any wall and away from any heat
registers.
2. Do not restrict airflow from entering or
exiting the humidifier.
3. Use Sears recommended bacteriostat
32-14900 to retard bacteria growth
that may cause odors and may be
harmful to your health.
4. Perform regular cleaning as instructed
in "Cleaning and Maintenance" section
of this manual.
5. Replace the evaporative wicking filters
at least once per humidification
season or more depending on water
conditions in your area.