Sagola 3300 GTO Manual De Instrucciones página 31

08. Functional Description of the Equipment
The SAGOLA 3300 GTO gun model (Gravity, Pressure and Suction) can be used for applying
appropriately diluted products (paints, lacquers, varnishes, etc.), used widely in the automotive
industry, timber industry, plastics, etc.
In the gravity or suction version; the product to be applied is placed in the cup provided for this
purpose, from which it flows by gravity or suction to the fluid tip and is then mixed with spraying air in
a way that can be controlled from outside the air nozzle.
In the pressure version; the product to be applied is placed in the pressure tank (hereinafter Reboiler)
or using a pressure pump. From here it flows through a hose to the fluid tip and is them mixed with
spraying air in a way that can be controlled from outside the air nozzle.
When the trigger is pulled back to the first position, it engages the air valve stem, opening this and
allowing air to flow through.
When the trigger is pulled back fully, the product needle is retracted, allowing the product to flow
out. This is then sprayed in the form of a fan.
When the trigger is released, the needle returns to its initial position, first closing off the product
outlet and then the air valve and application stops.
09. Tips and Needles Kits
SAGOLA supplies Nozzle Kits and Tip and Needle Kits of
different sizes for a variety of different applications. In order to
replace these, proceed as follows:
With the gun fully depressurised, remove the air nozzle.
Remove the Product Regulator with the spring and the spring stop and extract the needle to be
replaced. Remove the tip with the wrench supplied.
Fit the new tip and tighten. Now fit, in this order, the new needle, the spring and spring stop and
the product regulator. Lastly, fit the appropriate air nozzle.
There are Tip + needle Kits for this model of Ø 1.00, 1.20, 1.30, 1.40, 1.60, 1.80, 2.00, 2.20 and 2.80.
10. Air Nozzle Kits
Air Nozzle Kits:
GTO TECH, GTO HVLP, GTO EVO, 3300 EPA. 64S and 62S.
Air
consumption
L/min
Pressure
Bar
(*) PRESSURE FOR TEST CHECKER: With the HVLP nozzle You must not exceed the maximum inlet pressure of
1.8 bar. An excess pressure will create an additional over spray and will reduce the transfer.
www.sagola.com
GTO GTO
TECH HVLP
285 360
2
1,8 ( * )
GTO 3300
EVO EPA
255 250
2 2
an Elcometer company
64S 62S
310 270
2 2
EN 31