Sagola 3300 GTO Manual De Instrucciones página 34

an Elcometer company
11.3. Adjusting Air Pressure
11.4. Amount of Product to be applied
11.5. Application distance
12. Maintenance
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the compressed
air distribution network.
Do not apply excessive force or inadequate tools for maintaining and cleaning the unit. Some
repairs must be done with special tools on some occasions.
In these cases, you must contact the Customer Service of SAGOLA. Any handling of this product by
non-authorised personnel would render the warranty null and void.
The unit must be overhauled on a periodic basis to check the status of its components and replace
these when they are not in perfect condition.
In order to obtain the best possible results, always use ORIGINAL
SPARES. ensure total interchangeability, safety and operation.
EN 34
The gun leaves the factory with the internal flow regulator fully
open. In order to adjust this to the required pressure, turn the
regulator clockwise to reduce the inlet pressure and anticlockwise
to increase this.
Once the product to be applied has been adequately diluted, turn
the Product Regulator clockwise to reduce the amount of product
and anticlockwise to increase this.
During application, the amount of product applicable in areas that
are small or difficult to access can be reduced by reducing the
pressure applied with one's finger.
Adjust the distance between the air nozzle and the object to
cover to between 10 and 20 cm., depending on the application,
in accordance with this, the product to be applied and working
conditions, in order to increase transfer and obtain a reduction in
the amount of mist in accordance with the air nozzle used in each
case.
www.sagola.com