Descargar Imprimir esta página

Craftsman 917.377522 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

Lower handle
Lower Frame
Squeeze to
remove
Handle
bracket
Hairpin cotter
TO ASSEMBLE
GRASS
CATCHER
o Insert leg of tubular frame through front
opening of grass catcher and thread
frame into sewn hem of bag.
NOTE:
Keep bag hem gathered
on the
straight leg of the tubular frame.
• When frame comes out the other end of
sewn hem, Immediately
work the end of
frame down inside the bag as shown tn
Inset.
, Slide sewn hem evenly around the
tubular frame until both ends of frame
are exposed out of the front opening,
° Assemble
lower frame to tubular frame
as shown,
Be sure handle is outside of
bag and frames are fully seated as
shown in inset.
• Slip vinyl bindings over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before using.
• Close the flip lld. Fllp lid must be closed
while operating
lawn mower,
CAUTION:
Do not run your lawn
mower without clipping deflector
or
approved grass catcher in place.
Never
attempt to operate the lawn mower with
the rear door removed or propped
open.
Sewn
Tubular frame
_
[_
Flip lid
Tubular
Frame
(Frames must
be fully seated)
Lower frame handle
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to an
auth0rized
Service centei" for repair and
adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected carburetor problems, takeyour
lawn mower to an authorized service
center for repair and/or adjustment.
IMPORTANT; Never tamper with the
engine governor,which is factory set for
proper engine speed. Overspeedtng the
engine above the factory high speed
setting can be dangerous, If you think the
engine-governed high speed needs
adjusting, contactyour nearest
AUTHORIZED service center, which has
proper equipment and experience to make
any necessary adjustments.
15

Publicidad

loading