Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Installation
WARNING
MAKE SURE THE TAB ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE
IN THE HANGER BALL BEFORE ATTACHING
THE CANOPY TO THE BRACKET BY
TURNING THE HOUSING UNTIL IT DROPS
INTO PLACE.
Step 1. Tuck connections neatly into ceiling outlet
box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until it
locks in place at the narrow section of the key
holes. (Fig. 11)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws. NOTE: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
7.
Outlet box
Hanger
bracket
Figure 11
Attaching the Fan Blades
Step 1. Insert the blade through the slot in the
housing. Align the holes in the blade and the fan
motor assembly and secure with the blade support
and blade screw with lock washer. (Fig. 12)
Screws
Step 2. Repeat these steps for the remaining blades.
Canopy
Canopy cover
Blade support plates
Figure 12
Blades
Screws
Publicidad
