Publicidad
Idiomas disponibles
Idiomas disponibles
Blade Balancing
All blades are grouped by weight. The fan may
wobble even though the blades are weighed equally.
The following procedure should correct most fan
wobbling problems. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobbling problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of
one of the blades. Measure this distance as shown
in Figure 12. Rotate the fan until the next blade
is positioned for measurement. Repeat for each
blade. The distance deviation should be equal
within 1/8".
3. Use the enclosed Blade Balancing Kit if the blade
wobble is still noticeable.
4. If the blade wobble is still noticeable, interchanging
two adjacent (side by side) blades can redistribute
the weight and possibly result in smoother
operation.
WARNING
TO REDUCE THE RISK OF PERSONAL
INJURY, DO NOT BEND THE BLADE
HOLDERS WHILE INSTALLING,
BALANCING THE BLADES, OR CLEANING
THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN
BLADES.
Touching
ceiling
Figure 13
Installing the Decorative
Frame
Step 1. Remove 1 of the 3 screws from the mounting
ring and loosen the other 2 screws. (Do not remove)
Step 2. Place the key holes on the decorative frame
over the 2 screws previously loosened from the
mounting ring. Rotate the decorative frame in the
slots to align the points of the decorative frame with
points of the fan housing. Secure by tightening the 2
screws previously loosened and the one previously
removed. (Fig. 14)
Mounting ring
Figure 14
Decorative
frame
Screws
8.
Publicidad
