Publicidad
Idiomas disponibles
Idiomas disponibles
to the instructions shown in this manual.
Any apparatus serving and controlling the actuator must be produced according to the regulations in force and
respect the relevant standards issued by the European Community.
If the actuator is installed on a window at a height of less than 2.5 m from the floor and in buildings (public and
otherwise) in which the use of destination is not clear, it must be operated exclusively by a command which is not
accessible by public (key button).
The command button has to:
1) be placed at a height of 1500 mm from the floor
2) be positioned so that, at its activation, a person who carries the opening and closing has within its field of view
all the moving parts.
Do not wash the apparatus with solvents or jets of water. Do not immerse the apparatus in water.
Any repair must be carried out by qualified personnel (the manufacturer or an authorised service centre). Always
insist that only original spare parts are used.
Failure to use the original spare parts could compromise the correct operation of the product and the safety of
people or property, also annulling the effects of the guarantee enclosed with the apparatus.
In case of any problems or doubt, contact the point of sale where the product was purchased or the manufacturer directly.
3. TECHNICAL DATA
3.1
TABLE OF TECHNICAL DATA AND MARK
The CE mark certifies that the actuator conforms to the essential health and safety requirements laid down by
European product directives. The CE mark can be identified by the relevant adhesive label applied to the outside of
the product, on which are shown some of the data shown in the following table:
TECHNICAL DATA
TRACTION FORCE
PUSH FORCE
DIET
FREQUENCY
TYPE OF SERVICE
NO LOAD SPEED
RIDES AVAILABLE
OPERATING TEMPERATURE
IP PROTECTION DEGREE
SOFT START/SOFT STOP
CURRENT ABSORPTION
ABSORBED POWER
OBSTACLE DETECTION
PARALLEL CONNECTION
SYNCHRONIZATION
DIMENSIONS
OPENING LIMIT SWITCH
CLOSING LIMIT SWITCH
ACTUATOR WEIGHT
COLORS
CODE
***B00 black colour/W00 white colour/G00 gray colour
18
TECHNICAL FEATURES
250 N
200 N
230 VAC
50 HZ
S2 4min
16 mm/s
180 - 380
-5°C + 50°C
20
YES
0,14A
22W
YES
YES (MAX 30 ACTUATORS)
NO
41X79X265
SENSOR
AMPEROMETRIC
1.1KG
GREY/WHITE/BLACK
MSMART20H0***
SMART 20
250 N
200 N
110 VAC
60 HZ
S2 4min
16 mm/s
180 - 380
-5°C + 50°C
20
YES
0,14A
22W
YES
YES (MAX 30 ACTUATORS)
NO
41X79X265
SENSOR
AMPEROMETRIC
1.1KG
GREY/WHITE/BLACK
MSMART20I0***
250 N
200 N
24 VDC
-
S2 4min
16 mm/s
180 - 380
-5°C + 50°C
20
YES
0,9A
22W
YES
YES (MAX 30 ACTUATORS)
NO
41X79X265
SENSOR
AMPEROMETRIC
1.1KG
GREY/WHITE/BLACK
MSMART20L0***
Publicidad
