Snapper XD SXD21SPWM82 Manual Del Propietário página 25

TROUBLESHOOTING
PROBLEM
The mower does not
start.
The mower cuts the
grass unevenly.
The mower does not
mulch properly.
The mower is hard to
push.
The mower is
excessively noisy and
vibrates.
POSSIBLE CAUSE
The battery is not charged.
The switch is defective.
Grass jammed between the
deck and blade.
The battery is not fully inserted
in the mower.
Battery may require service or
replacement.
The lawn is rough or uneven. Check the mowing area.
The cutting height is not set
properly.
Wet grass clippings are
sticking to the underside of
the deck.
The mulching plug is missing. Install the mulching plug.
The grass is too tall, or the
cutting height is too low.
The rear of the grass catcher
bag is dragging in thick grass.
The motor shaft is bent.
The blade is unbalanced.
SOLUTION
Charge the battery.
Replace the switch (Contact an authorized service center).
Remove battery; check under deck for jams.
Check the connection between the battery and the mower. Make
sure the battery clicks into place.
Contact an authorized service center or replace battery.
Move the wheels to a higher setting.
Wait until the grass dries before mowing.
Raise the cutting height.
Empty the grass clippings from the grass catcher bag.
Stop the motor, and inspect for damage.
Repair before restarting. If vibration persists, contact an authorized
service center.
25