3c
INSTALL POP-UP DRAIN
• Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3)
and SEAL (4) as shown. Hand tighten PIVOT NUT
(2) Drop STOPPER (5) into drain.
(For vandal proof drain rotate stopper so PIVOT
ROD (1) goes through EYE (6) of STOPPER (5).
Make connection to "P" TRAP.
• Remove one end of CLIP (3) from PIVOT ROD (1)
by squeezing ends together while sliding.
• Insert PIVOT ROD (1) into second or third hole in
EXTENSION (7) and reassemble CLIP (3).
(EXTENSION (7) may need to be bent.)
• Adjust STOPPER (5) height by repositioning
EXTENSION (7) and tightening THUMBSCREW (8).
4
TEST INSTALLED FAUCET
• Remove AERATOR. With handles in OFF
position, turn on water supplies and check
all connections for leaks.
• Operate both handles to flush water lines
thoroughly. Operate LIFT ROD and check
DRAIN for leaks. Replace AERATOR.
5
IF FAUCET DRIPS PROCEED AS FOLLOWS:
• Aerator may accumulate dirt causing distorted and reduced water flow. Remove aerator and rinse clean.
• If spout drips, operate handles several times from OFF to ON position. Do not force-handles turn only 90˚.
6
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL
CLOTH. DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
5
8
7
1
3
2
4
6
AERATOR