Publicidad
Idiomas disponibles
Idiomas disponibles
Helpful tips
• To avoid splashing, start slowly and use the whisk in deep containers
• Move the whisk clockwise keeping it slightly inclined.
• Place the whisk in a container before turning on the appliance.
CHOPPER
The chopper is ideal for mincing meat, hard cheeses, onions, herbs, garlic, vegetables, bread, crackers, smoothies,
cocktails, mashed, or minced.
The maximum operating time is 20 seconds each time and the quantity must be less than 500gr.
Stop machining immediately if engine speed decreases and / or strong vibrations occur.
Helpful tips
• Cut food into small pieces for easier chopping.
• Remove bones, tendons and cartilage from meat to prevent damage to the blades.
• Make sure that the non-slip rubber ring is fixed to the bottom of the chopper.
Assembly and operation
• Carefully remove the plastic cover from the blade.
• The blades are very sharp! Always handle them carefully by holding them by the plastic top.
• Place the blade on the pin in the center of the chopper, press it down and turn it to lock it in its seat.
• Fill the food processor with food and put the lid on.
• Align the chopper with the motor body and hook the two parts until they click.
• Turn on the appliance to use the chopper. During processing, hold the motor body with one hand and the chopper
container with the other hand.
• Always chop solid foods at maximum speed.
• At the end of use, disconnect the appliance and remove the motor body.
• Remove the lid, remove the blade carefully before pouring the contents of the container. To remove the blade,
rotate it lightly and pull it carefully. Handle the blade with care because it is sharp!
• Do not use choppers to process very hard foods such as unpeeled nuts, ice cubes, coffee beans, grains or hard spices
such as nutmeg. Processing these foods can damage the blades.
ATTENTION: the use time must not exceed 20 seconds each time and the amount of food must be less than 500G.
CLEANING AND MAINTENANCE
When cleaning, pay attention to the following points:
• Remove the plug from the socket and wait for the product to cool. Do not immerse the engine in water.
• Clean the motor section with a damp cloth. Add detergent if it is very dirty.
• Clean the blades and the bottom of the mixer under running water. Handle the blades with care because they
are sharp!
• The chopper lid can be rinsed under the tap, but do not immerse it in water.
• Do not use steel wool, solvents or abrasives to clean plastic parts. Avoid touching the blades during cleaning!
• Make sure the hand blender is clean and dry before storing it.
• Do not use the appliance if:
✓ these instructions have not been followed and the blender has been modified
✓ the blender has been tampered with, mistreated or damaged
✓ the blender does not work due to the power circuit
10
Publicidad
