Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for selecting the ERA 700 Performance IP moving head lighting fixture from Martin®.
This Safety and Installation Manual is supplied with the fixture. It gives details of installing and servicing
the fixture as well as connecting to mains power. The ERA 700 Performance IP User Manual, containing
full instructions for connecting to control data, setting up, controlling and monitoring the fixture is available
for download from the ERA 700 Performance IP area of the Martin website at www.martin.com. If you
have any difficulty locating this document, please contact your Martin supplier for assistance.
Before installing, operating or servicing the ERA 700 Performance IP, please check the fixture's area of
the Martin website at www.martin.com and make sure that you have the latest user documentation for the
product.
Not all product specifications are included in the fixture's user documentation. You can find full
specifications for the fixture in the ERA 700 Performance IP area of the Martin website. The online
specifications include information to help you order accessories such as cables, flightcases etc.
The fixture is supplied with this Safety and Installation manual, an anti-tamper box to install over the
connections panel, and two Martin omega brackets for fastening a rigging clamp to the fixture base.
Before using the product for the first time
1. Check the support pages on the Martin Professional website at www.martin.com for the most recent
user documentation and technical specifications for the fixture. Martin user manual revisions are
identified by the revision letter at the bottom of the inside cover.
2. Read 'Safety information' on page 3 before installing, operating or servicing the fixture.
3. Unpack and ensure that there is no transportation damage before using the fixture. Do not attempt to
operate a damaged fixture.
4. Check that the voltage and frequency of the local power source match the mains power requirements
of the fixture.
5. Either hard-wire the fixture's power input cable to an AC mains power source or install as described in
this manual a power plug (cord cap) that is suitable for local power outlets on the power input cable
and connect the cable to an AC mains power outlet. If you need to fabricate a power cable, use only
the cable and connector specified in this manual.
Applying mains power
The fixture does not have an on/off switch. It becomes active as soon as AC mains power is applied at the
power input connector. Be prepared for the head to move and for the fixture to suddenly emit bright light.
Each time power is applied to the fixture, it will reset all effects and functions to their home positions. A
reset typically takes around 20 seconds.
Packing and unpacking
Allow the fixture to cool for 30 minutes before packing it for storage or transport in a flightcase or
packaging. If the fixture is wet, we recommend that you dry it before packing to avoid moisture affecting
protective packaging and potentially causing mold.
If you move the fixture from a cold to a warm environment, remove it from its flightcase or packaging and
give it at least two hours to acclimatize before you apply power. This will help to avoid damage due to
internal condensation. If condensation is still visible inside the front glass, run the fixture's dehumidification
function using the service menu. Note that you can also set the fixture to run the dehumidification function
automatically.
Shocks during transport can damage the tilt lock of a moving head fixture. Release the fixture's tilt lock
and make sure that the head will be supported by a flightcase insert or packaging before storing or
transporting the fixture.
24
Martin
®
ERA 700 Performance IP Safety and Installation Manual Rev. C
Publicidad
