CASO DESIGN M20 Ecostyle Manual Del Usuario página 51

 Front of device and operating panel
 Clean the front of the device and the operating panel with a soft, slightly damp cloth.
 Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth for
cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 The stainless steel surfaces can be cleaned with commonly available stainless steel
cleaners.
 Turntable, rolling ring
 The glass turntable must be removed and cleaned occasionally. Wash the plate in a warm
soapy solution or in the dishwasher.
 The rolling ring should be cleaned regularly to prevent excessive noise development or a
rotation malfunction.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
19 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
19.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
19.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Action
Close device door
Plug in mains plug!
Activate fuse
51