System Sensor OSI-RIE- Serie Guia De Inicio Rapido página 6

OPERATION MODES AND TROUBLESHOOTING GUIDE OSI-RIE-xx (SEE FIGURES 10. AND 11.):
Modes Red and
Remote Alarm
output
(LED 1)
Power on Off
Alignment Off
Initializing/ Com- Off
missioning
Normal Off
Alarm On
Trouble-Drift Off
Compensation
Trouble-Beam Off
Blockage
Trouble-Imager Off
saturation
Test activated- On
Pass Result
0333
20
Pittway Tecnologica S.r.l.,
Via Caboto 19/3,
34147 TRIESTE, Italy
DOP-LPB023
EN 54-12:2015
Line Detector using an Optical Beam, Fire Safety
EN 54-17:2005
Short Circuit Isolator
Please refer to the insert for the Limitations of Fire Alarm Systems.
For warranty terms, please refer to the Product Guide found at www.systemsensoreurope.com/products/category/beam-smoke-detectors/.
System Sensor® is registered trademarks of Honeywell International Inc.
Yellow and Remote Green
Trouble Output
(LED 3)
(LED 2)
Blink Off
Blink Off
Blink Off
Off Blink
Off Off
3 Quick Blinks Blink
4 Quick Blinks Blink
5 Quick Blinks Blink
Blinks the set sensi- Off
tivity by number of
blinks (1-4). Repeats
every 3 seconds till
reset.
Initiating means
Apply Power from dis- • All wiring correctly done.
charged state
• Address switches set.
Lever in 3:00 position and • Ready to perform alignment.
commissioning is active
• Follow guidance from the 4 arrows to correctly align.
Lock lever in 6:00 position • Commissioning and setting sensitivity.
to start commissioning
• Do not interrupt beam.
Successful completion of • Initializing finished.
initialization or detector
• Detector operates normal in quiescent condition.
reset
• Detector successfully reset.
Smoke, Test Filter or RTS- • Blinks till reset from FACP.
151KEY Test Station
Long Term Drift Reference • Reduced IR Signal
Out of 20% Range
• Clean detector and reflector.
Beam blockage or detector • Remove blockage or re-align detector
out of alignment
• Faulty unit.
Imager saturated • Sunlight or very strong light into detector or reflector.
• Re-position detector or reflector.
• Remove light source.
FACP or RTS151KEY • Remains in alarm until reset by FACP.
• Number of lit arrows indicates sensitivity level that was
selected automatically.
DISCLAIMER
4
Comments & Troubleshooting Tips
©2023 System Sensor. 01/16/2023
I56-6965-001