Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
Main Unit
•
Handle
•
Accessory Tray
•
High Pressure Hose
•
Spray Gun
•
Nozzle Extension with Quick Connect Fitting
•
Quick Connect Selector Nozzle
•
Oil Bottle
•
Hose Wrap
•
Detergent Siphoning Hose/Filter
•
Bottle Bracket Wireform (2)
•
PerfectMix™ Siphoning Unit/Hose
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Owner's Registration Card
•
Handle Fastening Hardware Kit (which includes):
•
Handle Bolts (2)
•
Carriage Bolt (2)
•
Rope Guide (1)
•
Plastic Knobs for Handle (2)
•
Plastic Knob (3)
•
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
All manuals and user guides at all-guides.com
ASSEMBLY
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Attach quick connect selector nozzle to nozzle extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
2. Insert handle carriage bolts (D) through holes from
NOTICE DO NOT fold the handle down while the engine is
hot.
3. Place accessory tray (F) over holes (G) on handle
4. Insert supplied accessories in spaces provided in
7
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
A
C
B
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine.
E
(viewing from back of unit). Push the tree clips (H) into
the holes until they sit flat against the accessory tray.
G
F
H
accessory tray. See How to Use Accessory Tray.
C
D
Publicidad
