Poulan Pro PP136 Manual De Instrucciones página 11

To stop engine:
• Release the throttle trigger,
• Move the ON/OFF switch to the OFF posi-
tion.
TRIMMER LINE ADVANCE
The trimmer line will advance approximately 2
inches (5 cm) each time the bottom of the
trimmer head is tapped on the ground with the
engine running at full throttle.
The most efficient line length is the maximum
length allowed by the line limiter.
Always keep the shield in place when the tool
is being operated,
To advance line:
• Operate the engine at full throttle,
• Hold the trimmer head paraltel to and above
the grassy area.
• Tap the bottom of the trimmer head lightly on
the ground one time, Approximately 2 inches
(5 cm) of line will be advanced with each tap.
Always tap the trimmer head on a grassy
area. Tapping on surfaces such as concrete
or asphalt can cause excessive wear to the
trimmer head.
If the line is worn down to 2 inches (5 cm) or
less, more than one tap will be required to ob-
tain the most efficient tine length.
_i WARNING:
use only 0.080" (2 mm)
diameter line. Other sizes of line will not ad-
vance properly and can cause serious injury.
Do not use other materials such as wire,
string, rope, etc. Wire can break off during
cutting and become a dangerous missile that
can cause serious injury.
CUTTING METHODS
_IWARNING:
Use minimum speed
and do not crowd the line when cutting around
hard objects (rock, gravel, fence posts, etc.),
which can damage thetrimmer head, become
entangled in the line, or be thrown causing a
serious hazard,
• The tip of the line does the cutting, You will
achieve the best performance and
minimum line wear by not crowding the line
into the cutting area, The right and wrong
ways are shown below.
Tip of line does Line crowded into
• For trimming or scalping, use less than full
throttle to increase line Iife and decrease head
wear, especially:
• During light duty cutting.
• Near objects around which the line can
wrap such as small posts, trees or fence
wire,
• For mowing or sweeping, use full throttle for
a good clean job.
TRIMMING - Hold the bottom of the trimmer
head about 3 inches (8 cm) above the ground
and at an angle. Allow only the tip of the line to
make contact, Do not force trimmer line into
work area.
Trimming
3 inches (8 crr
above ground
SCALPING - The scalping technique re-
moves unwanted vegetation down to the
ground, Hotd the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
at an angle. Allow the tip of the line to strike the
ground around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
MOWING - Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground, Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
Right W_ong
• The line will easily remove grass and
weeds from around walls, fences, trees and
flower beds, but it also can cut the tender
bark of trees or shrubs and scar fences.
11