Lutron Homeworks HR-REP-230-EU Instrucciones De Montaje página 2

Installation
1.
Find a suitable location for the Hybrid Repeater.
Place the repeater in a convenient and accessible
location. See System Communications (page 3).
2.
Connect Hybrid Repeater Link (if applicable).
Connect the Hybrid Repeater Link communication
wires from the HomeWorks
ous Hybrid Repeater in the daisy chain) to the ter-
minal block on the Hybrid Repeater (see Wiring
Diagram). Each terminal will accept up to three
0.5-1.0 mm 2 (22-18 AWG) wires.
Note: If using the plug-in adapter to power the
repeater, DO NOT connect the +15 V terminal
(terminal 2).
3.
Apply power to the Hybrid Repeater. If the Hybrid
Repeater is to be powered by the Hybrid Repeater
Link, apply power by turning on the Processor. If
the Hybrid Repeater is to be powered by the plug-
in adapter, insert the adapter cord plug into the
jack on the Hybrid Repeater, then plug the adpater
into a standard wall receptacle.
STATUS and
TEST LEDs will
be dimly lit when
first powered
Plug in
adapter jack
Wiring Diagram
HR-REP-230
(Side View)
4 MUX
3 MUX
2 +15 V
1 COM
2
Processor (or previ-
®
Plug in power
cord and
adapter
(optional)
Wall Mounting
Hybrid Repeaters may be wall mounted using the
supplied wall bracket.
1.
Attach wall bracket to wall using the supplied
screws and wall anchors.
UP
2.
Place power cord into notches at top and bottom
of wall bracket. Wrap excess power cord around
the cord holder. Route Hybrid Repeater Link wiring
through hole in wall bracket and out through side
cutout. Align repeater and snap onto wall bracket.
Hybrid Repeater
Link Wiring (option- Power Cord
al)
UP
Operation
RF AND WIRED TX/RX LEDs
Indicate activity on the RF and
Wired Links.
STATUS AND TEST LEDs
Indicates the status of the HomeWorks system. (See LED Status Guide,
page 4.)
Note: When the Hybrid Repeater is powered, but has not yet been
assigned an address from the HomeWorks Illumination Software, the
STATUS and TEST LEDs will be dimly lit.
STATUS Button
Used to address the Hybrid
Repeater from the
HomeWorks Illumination
® TM
Software.
TEST Button
Activates RF communica-
tion tests. To activate the
tests, press and hold the
TEST Button until the TEST
LED begins to flash.
Note: For communication
tests, the Hybrid Repeater,
HomeWorks Processor, and
other RF devices must first
be configured and
addressed using the
HomeWorks Illumination
Software.