Elektra Beckum TNS 150 W Instrucciones De Servicio página 13

Undo the hexagon nut (1) on the wet grinding wheel.
Remove all parts from the rotary shaft. The rear clamping
flange (5) remains on the rotary shaft. Clean the two
clamping flanges and carry out a sound test (Fig.8) on
the new grinding wheel.
Reattach the new grinding wheel as described above,
but in reverse order.
1 Hexagon nut (standard right hand thread)
2 Washer or split washer
3 Front clamping flange*
4 Wet grinding wheel
5 Rear clamping flange
'not required with al! TN models.
Cleaning
A
Caution! Always pull outthe plug prior to cleaning!
Every now and then clean the outside of the grinding
machine with a damp cloth.
Make sure to clean the inside of the grinding wheel
casing. The grinding wheels must always be able to run
smoothly within the casing.
Cleaning the water container
Remove the water container as often as possible and
clean it from the inside using water and a brush (no metal
brushes!).
Connection to Power Mains
Specifications
TNS150
TNS175 W
TNS175D
Power supply
Motor power P1
No-load speed
Grinding wheel 0
Grinding wheel width
1 - 230 V
330 W
2750/126 min*1
150/200 mm
20/40 mm
1 - 230 V
450 W
2750/126 mim1
175/200 mm
25/40 mm
3 ~ 400 V
570 W
2600/126 mim1
175/200 mm
25/40 mm
Machine noise information: workplace sound pressure Lp level below 80 dB(A).
12