FITFIU SAVAGE Manual Del Usuario página 107

Problem
• Axle broken
• Wheel out of true
• Hub comes loose
Wobbling wheel
• Headset binding
• Hub bearings collapsed
• QR mechanism loose
• Wheels not aligned in frame
Steering not accurate • Headset loose or binding
• Front forks or frame bent
• Inner tube old or faulty
• Tire thread/casing worn
• Tire unsuited to rim
Frequent punctures • Tire not checked after previous
• Tire pressure too low
• Spoke protruding into rim
• Low batteries
Bicycle has reduced • Faulty or old batteries
range • Low tire pressure
And/or speed
• Brakes dragging against rim
• Riding in hilly terrain, headwind, etc.
Hub motor makes a
"clicking" noise and has • Low batteries
reduce power and/or • Damaged planetary gears
shuts off
• Blown fuse
• Loose connectors
No power when the
• Broke wire
switch is turned "ON"
• Faulty switch
• Faulty controller
Bicycle operates OK • Loose connectors
but battery gauge does
• Damaged wires
not light up • Faulty battery gauge
Battery gauge lights
• Faulty brake inhibitor
up but bicycle does not
• Loose motor wire connector
operate
Bicycle runs at
• Faulty sensor
full speed without • Faulty throttle
pedalling • Faulty controller
Possible Cause
puncture
107
ELECTRIC BYCICLE SAVAGE
Possible solution
• Replace axle
• True wheel
• Adjust hub bearings
• Adjust headset
• Replace bearings
• Adjust QR mechanism
• Align wheels correctly
• Adjust /tighten headset
• Take bike to a bike shop for possible
frame realignment
• Replace inner tube
• Replace tire
• Replace with correct tire
• Remove sharp object embedded in tire
• Correct tire pressure
• File down spoke
• Charge batteries for recommended
time
• Replace batteries
• Inflate tires to recommended pressure
• Adjust brakes and/or rim
• Reduced range to be expected in these
• Types of terrain and/or weather
conditions
• Charge batteries for recommended
time
• Replace hub motor/wheel
• Replace fuse
• Check all connectors
• Inspect all wires for damage
• Replace switch and retest
• Replace controller and retest
• Check throttle and/or battery gauge
connectors
• Inspect all wires
• Replace battery gauge
• Replace brake inhibitor(s) and retest
• Check motor wire connector
• Replace sensor and retest
• Replace throttle and retest
• Replace controller and retest
EN