Franke Country FCO 86 H Manual De Usuario página 6

EN
Do not repair or replace any part of the
appliance unless specifically stated in the
user manual. Keep children away from the
installation site.
After unpacking the appliance, make
sure that it has not been damaged during
transport. In the event of problems, contact
the dealer or your nearest Aftersales
Service. Once installed, packaging waste
(plastic, styrofoam parts etc.) must be
stored out of reach of children - risk of
suffocation.
The appliance must be disconnected
from the power supply before any
installation operation - risk of electric shock.
During installation, make sure the appliance
does not damage the power cable - risk of
fire or electric shock. Only activate the
appliance when the installation has been
completed.
Carry out all cabinet cutting works
before fitting the appliance in the furniture
and remove all wood chips and sawdust.
Do not remove the appliance from its
polystyrene foam base until the time of
installation.
After installation, the bottom of the
appliance must no longer be accessible
- risk of burn.
Do not install the appliance behind
a decorative door - risk of fire.
If the appliance is installed under the
worktop, do not obstruct the minimum gap
between the worktop and the upper edge of
the oven - risk of burns.
Electrical warnings
Warning: The rating plate is on the
front edge of the oven (visible when the
door is open).
FCO 86 H / FCO 82 H
It must be possible to disconnect the
appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to the
user after installation.
Do not use the appliance when you are
wet or barefoot. Do not operate this
appliance if it has a damaged power cable
or plug, if it is not working properly, or if it
has been damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
- risk of electric shock. If the power cable
needs to be replaced, contact an authorized
service center.
Cleaning and maintenance
Warning: Ensure that the appliance is
switched off and disconnected from the
power supply before performing any
maintenance operation; never use steam
cleaning equipment - risk of electric shock.
Do not use harsh abrasive cleaners or
metal scrapers to clean the door glass since
they can scratch the surface, which may
result in shattering of the glass.
Make sure the appliance has cooled
down before cleaning or performing
maintenance - risk of burns.
Warning: Switch off the appliance
before replacing the lamp - risk of electric
shock.
6