Kenmore ELITE 721.80802 Instrucciones De Instalación página 11

STEP 3:
PREPARE THE VENTING BLOWER
WALL VENTED INSTALLATION:
1. Remove two blower unit mounting screws and one
blower plate screw. Remove the blower plate from
cabinet. See Figure 12.
2. Carefully lift the blower unit out of the microwave
oven. Disconnect the blower wire from connector.
See Figure 13.
3. Use side cutters or tin snips to cut and remove
knockouts "B" from Back plate. Discard knockouts.
Be careful not to distort the plate. See Figure 14.
4. Rotate the unit so that the exhaust ports face the rear
of the cabinet. See Figure 15. Before you insert
blower unit, blower wire must be like Figure 15.
5. Reassemble the blower wire into the connector.
6. Place blower unit back into cabinet. Check that the
exhaust ports face towards the rear of the cabinet.
See Figure 16.
7. Reattach the blower plate to the top of the cabinet as
it was originally assembled. Attach with one blower
unit mounting screw and then one blower plate
mounting screw. See Figure 17.
NOTE: When using wall venting,you need one
blower unit mounting screw.See Figure 17.
8. Go to STEP 4, PREPARE THE WALL AND UPPER
CABINET FOR INSTALLATION located on page 13.
blower unit
Knockouts "B"
connector
/
blower plate
back plate
_late
mounting screw
blower unit
mounting screw
Figure 12
blower wire
Figure 13
=
Parts "B"
Knockouts Parts "B"
Figure 14
exhaust
ports
Figure 16
blower
unit
Figure 15
_ lower plate
mounting
screw
blower unit _
exhaust
blower unit
mounting screw
Figure 17
11