Kenmore ELITE 721.80802 Instrucciones De Instalación página 12

STEP 3:
PREPARE THE VENTING BLOWER
ROOF VENTED INSTALLATION:
1.
2.
3.
4.
5.
6.
Remove two blower unit mounting screws and one
blower plate screw. Remove the blower plate from
cabinet. See Figure 18.
Carefully lift the blower unit out of the microwave
oven.
Rotate blower unit 90 ° so the exhaust ports face the
top of the cabinet. See Figure 19.
Place blower unit back into microwave oven.
Use side cutters or tin snips to cut and remove
knockouts "A" from blower plate. Discard knockouts.
Be careful not to distort the plate. See Figure 20.
Reattach blower plate to microwave oven. Attach with
the one blower unit mounting screw and then the one
blower plate mounting screw. See Figure 21.
NOTE: When using Roof venting,you need one
blower unit mounting screw.See Figure 21.
_ lower plate
mounting
screw
blower plate
blower unit
mounting screw
Figure 18
blower
unit
Figure 19
Knockouts "A"
blower plate
Figure 20
blower unit
blower plate
mounting
screw
blower unit
mounting screw
Figure 21
12