Midi Operation - TECshow NAVIGATOR 24 XL Manual De Usuario

Midi Operation

The controller will only respond to MIDI commands on the
MIDI channel that it is assigned to. All MIDI control is per-
formed using Note on commands. All other MIDI instruc-
tions are ignored. To stop a chase, send the blackout note.
Setting MIDI IN
1. While holding down the RECORD button simul-
taneously tap Flash button #1 three times. The
display reads MIDI CHANNEL IN to indicate chan-
nel setup is available.
2. Select the MIDI control channel (1-16) by tap-
ping Flash buttons 1-16. The relevant channel
LED lights indicating MIDI IN channel is set.
3. While holding down RECORD, tap the REC EXIT
button to exit MIDI SETTING.
MIDI note Function Turn ON/OFF
22-69 Trigger scenes 1-48 (100%)
70-117
118 FULL ON
119 DARK (momentary blackout)
120 HOLD
121 Turn on or off AUDIO
122 MODE: Chase-Scene
123 Mode: 1-12a 1-12b
124 Mode: 1-24a
125 Step
126 Blackout
127 Channel page (1-24, 25-48)
Observations
- This is the Channel that the controller will re-
ceive MIDI note commands.
P. 12
NAVIGATOR 24XL
ENGLISH VERSION
Setting MIDI OUT
1. While holding down the RECORD button simul-
taneously tap Flash button #2 three times. The
display reads MIDI CHANNEL OUT to indicate chan-
nel setup is available.
2. Select the MIDI control channel (1-16) by tap-
ping Flash buttons 1-16. The relevant channel
LED lights indicating MIDI OUT channel is set.
3. While holding down RECORD, tap the REC EXIT
button to exit MIDI SETTING.
Observations
- This is the Channel that the controller will trans-
mit MIDI note commands.
Receiving MIDI File Dump
1. While holding down the RECORD button simul-
taneously tap Flash button #3 (3) times. The dis
play reads MIDI FILEDUMP RECVING 000% when
the device is in the corrrect mode.
2. While holding down RECORD, tap the REC EXIT
button to exit MIDI setting.
Observations:
- This is the process of copying your entire show
to another Navigator 24XL. This will not work with
any other device.
- This process can take several minutes to com-
plete. The controller will automatically begin send-
ing the FILE DUMP once the mode has been se-
lected. Therefore, be sure that the other device
has previously been setup to receive the transfer.
- During FILE DUMP, all other operatioons will
cease to function.
- If errors or power failure occurs, FILE DUMP will
be interrupted and stop.