Create A Scene - TECshow NAVIGATOR 24 XL Manual De Usuario

Programming
Entering Record Mode (Record Enable)
1. While holding the RECORD button, tap the Flash but-
tons 1-5-6-8 in sequence.
2. Release the RECORD button. The Record LED lights up;

Create a Scene

A scene is a static lighting state. Scenes are stored in the
temporary memory, until they are transferred to one
of the playback faders. You may create a single scene or
a succession of up to 999 steps per Scene.
1. Record enable.
2. Select the 1-24 Single mode by tapping the
Mode Select button. This will give you control of
all 25 channels of the first page.
3. Compose a look by moving the FADERS.
(Changes in fixture atribute such as colors and
gobos, or simply dimmer values).
4. Press the Record to save the look into the
temporary memory.
5. Repeat steps 2-4 until you have your
desired scene.
6. Adjust the Speed and Fader sliders to achieve
the desired amount of time a scene will be held
in a chase (speed) and the amount of time al-
lowed for the fixtures to move from one scene to
the next (fade).
7. Select a Scene master to store your scene.
Tap the Page button to select a page (1-4).
8. Press and hold the Record button & tap the
Flash Button for the scene that you wish to store
it to. All LEDS will flash indicating the scene has
been programmed into memory.
9. You can continue programming or exit. To
exit program mode, press and hold the Record
button & tap the Rec Exit button.
P. 7
NAVIGATOR 24XL
ENGLISH VERSION