cecotec READY WARM 2000 THERMAL Manual De Instrucciones página 29

Wall assembly
1. Before installing it, make sure the appliance is placed at a minimum safety distance of 20
cm from any obstacle (walls, shelves, floor...).
2. Drill 2 holes on the wall with 140 mm between them.
3. Attach the wall supports (5) to the wall using the studs and screws provided.
4. Make sure the smaller-diameter side of the supports is hung from the wall.
5. Screw the wall support accessory (6) onto the 2 holes on the back-bottom part of the
device. Make sure the side with just 1 hole is against the wall.
6. Hang the appliance from the support.
7. Once hung on the wall, mark the free hole of the wall support accessory (6).
8. Remove the appliance from the wall, drill a hole where the mark is and introduce the
corresponding stud.
9. Finally, hang the appliance on the brackets and screw the mounting plate to the wall. Fig. 2
4. OPERATION
Automatic lock
- The buttons on the device's control panel will block if during operation no button is pressed
for 1 minute.
- To unlock it, press (-) for 3 seconds.
Note
The heater can be used manually or can be programmed.
Manual mode
3 operating modes:
- Day mode: The temperature can be adjusted from 5 ºC to 35 ºC.
- Sleep mode: The temperature can be adjusted from 5 ºC to 35 ºC.
- Anti-frost mode: The temperature can be adjusted from 5 ºC to 15 ºC.
Warning
For the device to be able to operate, the set temperature must always be higher than the room
one. The panel will display the room temperature. As the temperature shown on the display is
the one next to the device and not the real room one, when setting the temperature, select a
few more grades than desired ones.
Turning the device on
1. Connect the device to a power supply and turn the power switch on.
2. The control panel will flash and the "ºC" symbol, room temperature and power indicator
will light up. If this last symbol does not light up, press it.
READY WARM 2000 THERMAL
READY WARM 2000 THERMAL BLACK
ENGLISH
29