Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Self-tapping screw
(ø5 × 18 mm)
Hexagon socket
head cap screw
(M3 × 8 mm)
Terminal
caver
Hexagon
Wrench
Installation board, etc.
(thickness : 15 mm or more)
1. Install the installation fittings in the unit.
2. Attach the unit.
3. Install the terminal cover.
2CAUTION
• Do not install in the below locations;
(Unstable location, In a location that interferes with driving, In a location that gets wet, In a
dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that
gets hit by hot air)
• Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be
damaged.
• Install this unit in a location which allows heat to easily dissipate.
Once installed, do not place any object on top of the unit.
• The surface temperature of the amplifier will become hot during use. Install the amplifier in a
place where people, resins, and other substances that are sensitive to heat will not come into
contact with it.
• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check
that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or
wiring harness, and be careful not to cause scratches or other damage.
• Do not install near the dashboard, rear tray, or air bag safety parts.
• The installation to the vehicle should securely fasten the unit to a place in which it will not
obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may
cause injury or an accident.
• After installing the unit, check to make sure that electrical equipment such as the brake lamps,
turn signal lamps and windshield wipers operate normally.
Self-tapping screws
(ø3 × 8 mm)
Mounting
Hardware
English
3
Publicidad
Tabla de contenido
