Mastro AJA0001 Instrucciones De Uso página 4

INSTRUCTIONS MANUAL
GRILLS
1. Choose a dry suitable place for the grill.
a) The grill should not be installed close to inflammable or heat deformation products.
If this is not possible, the grill working-place has to be isolated with a good thermic
non-inflammable material.
b) Chose the least wet place possible to place the grill
2. Before connecting the grill to the power supply, check if the circuit specifications are
correctly adjusted to the grill power. The electric board (power mains) should have a
30mA protection and a circuit breaker with a 3mm separation between the contacts.
a) In the rear part of the machines there's a terminal marked
equipotencial connection between several machines.
A
LWAYS CONNECT THE GRILL TO A PLUG WITH AN APPROPRIATE EARTH CONNECTION
"T".
USE TYPE
3. Turn the thermostat(s) to the required temperature up to a maximum of 250ºC (482ºF).
The thermostat(s) led lights up, and turns off when the set temperature is reached.
4. While the set is working do not touch the metallic parts once they are very hot.
5. CAUTION
T
O CLEAN THE GRILL
NEVER USE WATER DIRECTLY ON THE MACHINE
6. If by accident water is spilled over the grill, it should be immediately disconnected from
the power supply and it should be properly dried, before it is used again.
7. It is possible to regulate the tension of the upper plate by turning the screw on the upper-
back part of the grill, by using the hole-key supplied with the grill.
8. If the power cable needs to be replaced, a cable type H05RN-F 3G 1mm2 for the single
plate grills, and a cable type H07RN-F 3G 1.5mm2 for the double plate grills, must be used.
• For the United States of America and Canada, the cable should be of the type SJTO - 14
AWG PVC 105ºC.
9. The machine has a manual rearm safety thermostat, which completely turns off the
machine whenever there's a malfunction in the temperature control system. In order to rearm
the thermostat it's necessary to remove the lower body panel.
This operation should only be carried out by qualified technicians.
,
FIRST DISCONNECT IT FROM THE POWER SUPPLY
.
which allows the
:
DO NOT
. U
SE A WET CLOTH AND