Volkswagen 7C0 055 204 B Instrucciones De Montaje página 11

Route the red/white, red/blue, red/violet and red/yellow ends of the 9-wire wiring harness up to the
12-wire fuse carrier in the seat console and in the respective unoccupied output side fuse slots
and click into place.
In case the fuse carrier is not available, an additional fuse carrier
000 055 212 B / 65.25434-6000 must be used. In this case, slots 1 - 4 must be used (see table 2).
Wire Fuse slot no.
red/white
red/blue
red/violet
red/yellow
Then the four supplied flat pin fuses must be inserted into the respective fuse slots.
Route the orange/brown, orange/green, violet/black and black/red wire ends of the 9-wire wiring
harness to the BCM (Body Control Module).
Unlock the slot "C" connector housing on the BCM and then pull the connector strips out of the
housing casing. First remove the cable ties at the cable outlet of the connector housing.
Push out the socket contact of the vehicle's black/red wire from chamber 58 and insert it into
chamber 2 of the supplied 3-way black socket housing and click into place.
Insert the socket contact of the black/red wire end of the 9-wire wiring harness into the now free
chamber 58 and click into place. Reinsert the connector strips into the housing casing, lock and then
use a 143 mm cable tie to secure them in place.
Unlock the slot "A" connector housing on the BCM and then pull the connector strips out of the
housing casing. First remove the cable ties at the cable outlet of the connector housing.
Push out the socket contact of the vehicle's orange/green wire from chamber 16 and insert it into
chamber 3 of the supplied 4-way brown socket housing and click into place.
Push out the socket contact of the vehicle's orange/brown wire from chamber 17 and insert it into
chamber 4 of the 4-way brown socket housing and click into place.
Push out the socket contact of the vehicle's red/blue wire from chamber 14 and insert it into
chamber 1 of the 4-way brown socket housing and click into place.
Insert the socket contacts of the orange/green, orange/brown and violet/black wire ends of the 09-
wire wiring harness into the now free chamber 16 (orange/green), chamber 17 (orange/brown)
and chamber 14 (violet/black) and click into place. Reinsert the connector strips into the housing
casing, lock and then use a 143 mm cable tie to secure them in place.
Plug the 3-way black and 4-way brown pin housing of the wiring harness into the previously fitted 3-
way black and 4-way brown socket housings, click into place and then use a 143 mm cable tie to
secure them to the vehicle's wiring harness.
06.04.2020-071973
Fuse
strength
1 20A
2 20A
3 15A
4 15A
Table 2:
Power supply trailer lighting right
Power supply trailer lighting left
Permanent positive trailer power supply (Ter. 30)
Power supply charging cable trailer (Ter. 15)
Function
11 / 85