Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
IMPORTANT SAFETY INSTRUCTIONS
w
FOR YOUR SAFETY
. For Personal Safety, remove house fuse or open
circuit breaker before beginning
installation.
Failure to do so could result in serious injury or
death.
. Be sure your cooktop
is installed properly by a
qualified
installer or service technician.
. To eliminate the risk of burns or fire due to
reaching
over heated surface elements, cabinet
storage located above the surface units should
be avoided. If cabinet storage space is to be
provided, the risk can be reduced by installing a
range hood that projects horizontally
a minimum
of 5" beyond the bottom of the cabinets. Cabinet
installation
above the cooktop
may be no deeper
than 13".
. Make sure the cabinets and wall coverings
around the cooktop
can withstand
the
temperatures
(up to 200°F) generated
by the
cooktop.
. The cooktop should be easy to reach and lighted
with natural light during the day.
. Always disconnect
the electrical
service to
the cooktop before repairing or servicing the
cooktop. This can be done by disconnecting
the
fuse or circuit breaker. Failure to do this could
result in a dangerous
or fatal shock. Know where
your main disconnect
switch is located. If you do
not know, have your electrician
show you.
ELECTRICAL REQUIREMENTS
This appliance
must be supplied with the proper
voltage and frequency,
and connected
to an
individual,
properly grounded
branch circuit,
protected
by a circuit breaker or a time delay fuse
as noted on name plate.
We recommend
you have the electrical wiring and
hookup of your cooktop
connected
by a qualified
electrician.
After installation,
have the electrician
show you where your main cooktop
disconnect
is
located.
Wiring must conform
to National Electrical Code
and all local electrical
codes. You can get a copy
of the National Electrical Code, ANSI/NFPA No.
70-Latest
Edition, by writing:
National Fire Protection
Association
Batterymarch
Park
Quincy, MA 02269
In Canada, wiring must conform
to Canadian
Electrical Code (CEC).
The cooktop conduit wiring is approved
for copper
wire connection
only, and if you have aluminum
house wiring, you must use special UL approved
connectors
for joining copper to aluminum.
In
Canada, you must use special CSA approved
connectors
for joining copper to aluminum.
You must use a two-wire,
three conductor
208/240
VAC, 60 Hertz electrical
system. A white (neutral)
wire is not needed for this unit.
Refer to the name plate on your cooktop for the
KW rating for your cooktop.
These cooktops
require SO amp service.
T
Name plate location
Publicidad
