Publicidad
Idiomas disponibles
Idiomas disponibles
Notes:
OPERATIONS
1. Set the TIMER switch to OFF,
sian
4. Load a pre-recorded cassette.
.
——
rection of tape running is r e v e r s e d
to
:
f
i t c h
i
t
din
thi
we rowed foreach
of Dasa | =D
sarcomere
will
continue
t
Deck Il; use the appropriate NR
side. at which point play of recording is
switch for the deck used.
—
© pune:
i
-
6. If Deck | is used, be sure its PITCH CONT
es
Beginning
when dhe tape reacties the end. play
knob is set to the center position unless
Side A
or recording is released
tape speed control (mentioned later) is
required.
|
7. Press the ~¢ or ® button.
PLAY mode (Tape loaded in Deck | or Il) |
8. Adjust the volume with the amplifier's
|
control.
P
Side B
Beginning
End
During either forward or reverse play,
when the end of tape is reached, the
direction of tape running is reversed and
play continues in the opposite direction, In
this way, the two sides of the tape are
Using PITCH CONTROL (Deck |
|
played back continuously; the tape will
only)
End
oar
Beginning
stop after 5 cycles.
le
Using the PITCH CONT knob, Deck I's pitch
ca |
control (tape speed) in the play mode is
A
possible. The variable range of tape speed is
| RECORD mode (Tape loaded in Deck | or Il)
plus or minus 12% from normal speed: 4.76
=
Side B
cm/sec (1-7/8 ips). With this control in its
Beginning
End
|
center click "0" position, the tape speed will
be normal speed. Turning the control toward
speed,
-
Note:
When
using the PITCH CONT, be
End
.
Beginning
sure to use non-Dolby NR encoded
|
See
tapes. If a Dolby NR encoded tape is
CONTINUOUS REC/PLAY
played back, the sound may not be
Refer to the following.
Teproduced properly.
\¢ Continuous Playback Operation chart on page 7.
+ Continuous Recording Operation chart on page 11.
|
Publicidad
