Greencut GE200XE Manual De Instrucciones página 64

64
TROUBLESHOOTING
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance so that the machine continues to function properly. The table includes some of the most common
problems, their possible causes and solutions.
PROBLEM
• Fuel tank is empty
• Clogged fuel filter
The engine
• Spark plug wire disconnected
fails to start
• Defective spark plug
• Defective spark plug
• Loose spark plug wire
• The unit continues to operate with the
choke
Power loss;
• Fuel line clogged
Irregular
• The fuel tank is almost empty
operation
• Carburettor requires a reset
• Dirty/clogged air filter
• Fuel tank dirty
The motor • Low level of engine oil
overheats • Debris around the engine
• Loose motor support plate
The unit
• Damaged blades
vibrates • Debris stuck on the blades
• Uneven surface
The unit does
• The shredder is blocked
not discharge
The unit does • The unit takes longer to process the
not work material
NOTE: If you can not solve the problem, contact the Official Technical Service.
POSSIBLE CAUSE SOLUTION
• Fill the fuel tank with the correct fuel
• Clean the fuel tank
• Connect the wire to the spark plug
• Clean the spark plug
• Replace the spark plug
• Tighten the spark plug connection
• Move choke lever to normal state
• Clean the fuel lines
• Fill the fuel tank
• Consult your local distributor
• Clean or replace the air filter
• Clean the fuel tank
• Fill with the correct level of oil
• Turn off the unit and clean around the
motor
• Tighten the support plate
• Check the blades and replace them if
necessary
• Check the blades and remove any debris
• Place the unit on a flat surface
• Disconnect the spark plug wire and then
clean the shredder
• Add dry material or a mixture of different
materials
• Reduce the volume of material in the
conduit
• Check that the blades are not broken
• Check and replace the blades
• Replace or sharpen the blades
• Check that the belt is properly tensed