Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ABOUT POWER LAMP
The power lamp indicates various statuses for the
gardening appliance. (Fig. 5)
Table 5 shows the various statuses indicated by the
power lamp.
Table 5
State of lamp
Off
Red
The lever is being pressed while
Blinking red
the overload protection circuit of
the gardening appliance is operating.
The main pipe is not fully extended.
(CG36DAL(L))
Quickly blinking red
The gardening appliance is
operating abnormally.
Power Lamp
ABOUT REMAINING BATTERY INDICATOR
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 6) When
releasing your finger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off. The table 6 shows the state of remaining
battery indicator lamp and the battery remaining power.
Status of Gardening appliance
Power OFF
Power ON
Switch Panel
Fig. 5
State of lamp
Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
differently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator switch
Remaining
battery
indicator lamp
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
When using a back pack power supply (BL36200),
please check the battery level on the battery level
display of the back pack power battery. For details,
please see the BL36200 instruction manual.
PRIOR TO OPERATION
CAUTION
Pull out battery before doing any assembly.
1.
Installing the loop handle (Fig. 7)
(1) Remove the finger-tight M6 × 43 bolts (2 pcs.).
(2) Install the loop handle on the main pipe so that it
leans against the housing.
(3) Place the handle fixture at the lower end of the
main pipe and secure it firmly using M6 × 43 bolts
(2 pcs.) and M6 nuts (2 pcs.).
English
Table 6
Fig. 6
15
Publicidad
Tabla de contenido
Solución de problemas
