Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT DESCRIPTION
Contents of the box
1# estructura base/base structure
aceite silicona/
instrucciones/
silicone oil
instructions
OPERATION
1. Plug in the power, put the protection device, turn on the power
switch, display the program code first, and then enter the standby
state after the full display initial, single display speed 0.0.
2. in the standby state, press the PORG key, you can select
manual and 6 automatic modes.
3. In the standby mode, press the start/stop key to enter the
running state, and the initial speed
is single display. In the running state, press the start/stop key to
change the standby initial after the system stops.
4. in the manual operation state, through the increase/
deceleration key, the running speed can be set to 1.0km/h-
8.0km/h. The running time is sequential timing and cannot be set.
It will automatically stop after 60 minutes.
5. In the automatic operation mode, the speed runs according
to the corresponding set value of the program, and when the
switching speed is finished every beat, the buzzer will be made 3
seconds in advance to prompt the user. In automatic mode, you
can also adjust the speed, and automatically load the table speed
to the next beat. The automatic mode runs for 20 minutes and
cannot be set.
6. in the running state, the initial preparation stage of 3 seconds,
and then into the real running state, you can use the MODE key
to switch the display mode, respectively, speed - distance - time
llave/ key 6mm
- calories - display. During the display, an automatic switch is
performed every 5 seconds.
7. when running, press the add/slow down key, forcibly cut to the
speed display, 3 seconds later return to the original display.
8. When in PROGRAM mode, press the PROG (PROGRAM) button
to select your chosen workout (P01 to P6). Press the SPEED + or
SPEED - button to change the setting. Press the START button to
confirm and start your workout.
11
Remote control
Press the button to start/stop
training on different training mode
+
immediately.
M
Press the button to select the pre-
set training program (P01-P06)
P
-
mode before training.
Press the button to make upward
M
adjustments for the speed.
P
Press the button to make backward
+
adjustments for the speed.
Press the button to switch the
-
display.
EN - MC-80
Publicidad
