Injecta GEA R MT Manual De Instalación página 13

Paragraph 15 – Level Alarm
Programming
PROG
-­‐
-­‐
Alarms
Level Stop
-­‐
Paragraph 16 – Flow Display Unit
Programming
Paragraph 17 - Setting the Pause
Programming
PROG
Configuration
+
Paus
N.Open -­‐
Display contrast adjustment.
For adjusting the display contrast keep the key
to increase or decrease the contrast.
EM00136290
Alarm Level
Stop -­‐
Alarm Flow
Alarm
ESC
Alarms
Level Alarm
-­‐
-­‐
+
-­‐
DosingPump.ir
rev. 1.0
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
using the keys to set the alarm type. Confirm by
pressing the
the main menu
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
using the keys to set the unit of measurement,
choosing between L/h (liters/hour), Gph (Gallons/hour), ml/m
(milliliters/minute) or standard (% or frequency, depending
on settings). Press
main menu
The pump can be paused by remote input.
The factory setting is Normally Open.
Changes can be made by pressing the
then using the
OPEN or N. CLOSED).
Press to confirm and return to the main menu.
pressed and within 5 seconds press the keys
EN
Operation
key. Press to return to
Operation
to confirm and return to the
Operation
keys to set the new value ( N.
key, then
key, then
key,
or
11