Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Wok Grate & Tea Kettle Grate
Woks are often used for stir-frying and pan frying. To use a Wok, you need to attach the Wok
Grate so your Wok will sit on the burner properly and safely.The tea kettle grate is usually used
for small pans smaller than 6in.
1.the wok grate and the tea kettle grate can only be placed on the versatile tri-Ring burner cook-
ing grate,or the rapid burner cooking grate
2. Do not use both the wok grate and the tea kettle grate on the same burner.
Wok Grate
Tea Kettle Grate
Step 5: Check the ignition and flame quality
Nota
Make sure the knob is in the "OFF" position before starting operation, if it is not, turn the knob
clockwise.
Check the ignition
• This appliance is equipped with an electronic ignition device. Simply press the knob down-
ward and turn it counterclockwise to HI. Then, you will hear clicking sounds, which indicates
proper operation of the ignition system.
• Once air is purged from the supply line, the burner should light within 3-5 seconds, and the
clicking sounds will stop.
• After the burner lights, rotate the knob to your desired position.
• Try each burner in succession until all burners have been checked.
Check the flame quality
• Determine the quality of flames visually. Normal burner flames should look like following 2
pictures.
• Long, bright yellow flames are not normal. Normal flames may show signs of an orange tint
when well heated or signs of flickering orange due to particles in the gas or air.
-17-
All FOTILE gas cooktops are manufactured and shipped to be used with natural gas. The cooktop
are also shipped with LP Conversion Kits (a set of properly-sized burner orifices, the pressure
regulator could use for both natural gas and LP), so the cooktop can be converted to be used with LP
gas. Please follow instruction when converting.
LP Conversion Kits
Nozzles for LPG (5)
GLG30301
BURNER ORIFICE SIZES AND OUTPUT RATINGS
(LP Gas [Propane] 10 in WCP)
BURNER
Versatile Tri-Ring Burner
Semi Rapid Burner
Simmer Burner
Rapid Burner
Requipped tools
Adjustable wrench
9/32" open-end wrench
Phillips screwdriver
3/16" Flat-blade screwdriver
To convert your cooktop for use with LP gas, perform the following steps
and procedures:
1. Disconnect electrical power to the cooktop. Unplug the cooktop power cord, trip the circuit
breaker, or remove the fuse from the fuse box.
2. Shut off the gas supply to the cooktop. Close the manual shut-off valve to the cooktop.
LP Conversion Instructions
Nozzles for LPG (6)
GLG30401-Y/GLG30401
BTU RATE
Orifice size [mm]
15000
In:0.6/Out:0.7(2 pcs)
4500
0.65
3000
0.55
9100
0.92
Nut drivers:9/32"or 7mm
-18-
Publicidad
