Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
• Pressure regulator installation
Install the pressure regulator with the arrow pointing in the direction toward the bottom of
the cooktop base and in a position where you can reach the regulator access cap.
B
A
C
D
Step 3: Electrical connections
The electrical system, including the power cord, is preinstalled and
WARNING
prewired at the factory. Altering any part of this system may result in a
short or overload.
• All gas cooktops come with a power cord. The power cord is connected
to the bottom of the cooktop
• Plug in the power cord. Make sure the outlet meets local or national
electrical codes
Step 4: Burner components and grate installation
Outer Burner Cap Burner Head Inner Burner Cap
L:18000BTU, Versatile Tri-Ring Burner
Burner Cap
Burner Head
Burner Cap
75
CR:5800BTU,Semi Rapid Burner
CF:3000BTU Simmer Burner
-13-
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Up arrow.The arrow is on the
bottom of the pressure regulator.
Burner Head
Burner Cap
Burner Head
50
90
R:13200BTU,Rapid Burner
Burner components installation
Tri-Ring burner assembly:
1. Hold the burner head so the shiny silver side is facing down. Find the small hole in the burner
head as noted in this picture.
2. Place the burner head onto the cooktop surface so that "hole A" gets inserted into "pin B" on
the cooktop. Make sure "Pin B" is firmly seated into "hole A" on the Burner Head. If not,
remove the burner head and try it again. Please refer to the pictures below for this step.
3. Place the lined part of outer burner cap to fit in the lined part of the burner head. Shake the
outer burner cap gently to check if it is firmly seated (you will be able to rotate the outer burner
cap, but it should be firmly seated in the burner head.)
4. Next, place the inner burner cap on the burner head and make sure it is firmly set by gently
sliding it from side to side.
Installation instructions
A
B
-14-
Publicidad
