Publicidad
Idiomas disponibles
Idiomas disponibles
3. HOW TO OPERATE
When moving the instrument from a warm environment into a cool environment,
CAUTION!
moisture may accumulate on the Laser Beam Window
the new environment first.
turn on a wet or damp instrument. To wipe the Laser
DO NOT
Beam Window
, use
a lint-free cloth.
1
ONLY
Laser beam expands as the distance between the instrument and the target
PLEASE NOTE:
increases. Therefore, always take measurements in the center of the laser line.
Installing the Batteries
Before installing or replacing the batteries, make sure that the Pendulum Switch
is in the LOCK position, and the power is turned OFF.
Open the Battery Compartment Cover
1.
Insert the batteries observing the polarity. Ensure that the removal band is positioned
2.
under the batteries.
3.
Close the Battery Compartment Cover
. Allow the instrument to adapt to
1
DO NOT USE A PAPER TOWEL.
by pushing the latch
and lifting it.
8
7
8
until it engages.
12
Powering ON/OFF:
The instrument can be used in either a Self-Leveling Mode (for level applications) or
Pendulum-Locked Mode (for inclined applications).
Powering ON/OFF in the Self-Leveling Mode:
In this mode, the laser beam self-levels within ± 4° to project horizontal and vertical laser lines.
Before powering ON, place the instrument on a firm and level surface.
1.
Slide the Pendulum Switch
2.
it stabilises.
2
NOTE:
If the instrument is tilted beyond its self-leveling limits (± 4°), the Pendulum
Locked Indicator
instrument until the beam stabilises and the indicator stops flashing.
To power OFF, slide the Pendulum Switch
3.
ON/OFF Button
Powering ON/OFF in the Pendulum-Locked Mode:
In this mode, the self-leveling capability is disabled, and the laser level can be tilted to
project horizontal and vertical laser lines at an incline.
Press the Power ON/OFF button
1.
2.
Pendulum Locked Indicator
(approx. every 6 seconds).
To power OFF, press the Power ON/OFF Button
3.
to the UNLOCK position to activate the laser and wait until
2
will flash and the laser beam will rapidly flash. Reposition the
4
to the LOCK position and press the Power
2
5
.
for three seconds to activate the laser.
5
will flash and the laser beam will slowly flash
4
.
5
13
Publicidad
