Qilive Q.6317 Manual De Instrucciones página 24

EN Problem
Dishwasher
doesn't start
Drain pump
doesn't stop
Noise
Foam in the tub
Stained tub
interior
White film on
inside surface
Possible Causes
Fuse blown, or the
circuit breaker tripped.
Power supply is not
turned on.
Water pressure is low
Door of dishwasher
not properly closed.
Overflow
Some audible sounds
are normal
Utensils are not
secure in the baskets
or something small
has dropped into the
basket
Motor hums
Improper detergent.
Spilled rinse aid.
Detergent with
colourant may have
been used.
Hard water minerals.
What To Do
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely. Make
sure the power cord is properly plugged
into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
Make sure to close the door properly and
latch it.
The system is designed to detect an
overflow. When it does, it shuts off the
circulation pump and turns on the drain
pump.
Sound from detergent cup opening.
To ensure everything is secured in the
dishwasher.
Dishwasher has not been used regularly.
If you do not use it often, remember to
set it to fill and pump out every week,
which will help keep the seal moist.
Use only the special dishwasher
detergent to avoid suds. If this occurs,
open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to
the tub. Close and latch the dishwasher,
then start the "pre-rinse" wash cycle to
drain out the water. Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure that the detergent has no
colourant.
To clean the interior, use the damp soft
cloth with dishwasher detergent and
wear rubber gloves. Never use any
other cleaner than dishwasher detergent
otherwise, it may cause foaming or suds.
24