GE AEM05 Serie Manual Del Propietario Y Instrucciones De Instalación página 5

ge.com
Do Not Operate in Freezing Outdoor Conditions
This cool<rely air conditioner was not designed for
fleezing outdoor conditions. It illust not be used in
fleezing outdoor conditions.
Remote Control
To ensure proper operation, aim file remora
conuol at the signal receiver on the air
condifioneL
Tile remote conuol signal has a range of
up m 20 feet.
Make sure riDdling is between die air conditioner
and the remora conuol that could block the
sigmal.
Make sure batteries are flesh and instaUed
correctly _tsindicated on the remora conuol.
Cool Mode
Use file
Coolmode
at Low,Med, Highor AutoFan
Speedfor cooling. Use tile Temperature I ncrease• /
Decrease • pads to set tile desired temperature
between 64°F and 86°F in 1°F increments.
An electronic fllemlostat is used to maintain file
room temperature. Tile compressor will cycle on
and off to keep file room at file set level of comfort.
Set file themlostat at a lower number and file indoor
air will become cooleL Set die fllelInostat at a higher
number and file indoor air will become wamleL
NOTE: If theair conditioner i s off andis thenturnedon
whileset toa Coolsettingor if turnedfroma fansetting
toa Coolsetting,it maytakeapproximately 3 minutes
forthecompressor to startandcoolingtobegin.
Cooling Descriptions
For Normal Cooling--Select the Cool mode and
High or Med fan with a middle
set temperature.
For Maximum Cooling--Select tile Cool mode
and High fan with a lower set temperature.
For Quieter & Nighttime Cooling--Select tile
Cool mode and LOWfan with a middle set
tempemtme.
Energy Saver Mode
Controls tile fan.
ON--The fan will cycle on and offwifll file
compressoL This results in wider variations of room
temperature and humidity. Normally used when tile
room is unoccupied. NOTE: The fan may continue to run
for a short time after the compressorcycles off.
OFF--The tim runs all tile time, while file
compressor cycles on and off:
Fan Only Mode
Use the FanOnlyMode at Low,Medor Highfan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a Set mmperamre camlot be
enmred. Tile room mmpemmre will appear
in tile displ W.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Auto Fan Speed
Set to Autofan speed for tile fan speed to
automatically set m tile speed needed m provide
optimum comfort settings wifll tile set temperature.
If the room needs more cooling, the fan speed
will automatically incre_tse. If the room needs less
cooling, the fan speed will automatically decrease.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Power Outage Recovery Feature
In tile case of a power outage
or interruption, tile
unit will automatically re-start in the settings last
used after tile power is restored.
If tile Delay 1-24hr
feature was set, it will resume countdown. You may
need to set a new time if desired. 5