mnstaliation
mnstructions
REVERSING THE DOOR SWING
(CONT.)
[] TRANSFER
BOTTOM
HINGE
BRACKET TO THE LEFT
For models
with
a base
grille,
remove
it b) ,grasI)ing,
it
about
6" fl'om
each
end
and
pulling
its bottom
edge
toward
_ou,
Using a Torx': dfive_; move the bottom
hinge bracket
and plastic washer fl'om the right side to the left side.
NOTE:
If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom
of the dora:
t
I
PlasticWasher
o.J
/
#\
For models
with a base grille, befl>re replacing
the
base grille,
remoxe
the grille
cap b) remoxing
the
screw. Screw
the cap to the opposite
side.
Replace
the base grille by inserting
the tops of the
metal clips into the ox_fl vents, making
sure one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then
push the bottom
of the grille
forward
tmfil it snaps into place.
[] TRANSFER
CENTER HINGE
BRACKET TO THE LEFT
Remo_e tile center
hinge bracket
by removing
the
three Torx <_> sci'ews.
NOTE:
Kee I) these screws with the hinge bracket.
They are long screws and will be used when
installing
the hinge
on the other
side.
On some models,
you will need
to remove
the colo_
matched
caps fl'om the screw heads
befi)re you can
remoxe
the screws. Use the edge of a thin flat blade
to
genfl)
pi T tile caps off the screw heads.
(A put_' knife
works well for this.) Coxer the blade with tape to
prex ent scratching,
the I)aim.
Remoxe
the three
Torx
screws f_om the center
left
side of the cabinet.
Screw
them
into
the holes on
the right side.
Place the center
hinoe
bracket
oxer the holes at
the center
left side of the cabinet.
Insert
and
tighten
the three
long screws.
Replace
the caps b) snapping
them
oxer the screws
with your finger.
[] TRANSFER
DOOR STOPS
On each doo_, mo_e the metal door stop from
the
fight to the left.
Moxe any screws from
the left to the fight.
DoorSto
\
Left Side
Right Side
2O