Descargar Imprimir esta página

Cub Cadet i1042 Manual Del Operador página 8

Ocultar thumbs Ver también para i1042:

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly & Set-Up
3
Opening the Tractor Hood
To attach the negative battery
cable and check the engine
oil level the hood must be open. Locate the hood lift notch
(Refer to Figure 4 on page 10) at the front/center
of the
dash panel. Grasping the hood at the notch, lift and pivot
the hood forward to open.
Attaching the Battery Cables
The tractor is shipped with an activated
sealed battery. The
positive battery cable is factory connected.
The negative
cable must be connected.
The positive battery terminal
is
marked Pos. (+). The negative
battery terminal
is marked
Neg. (-).
IMPORTANT: Make sure the ignition switch is in the "OFF"
position before attaching
the battery cables.
From the center notch at the front of the dash panel,
lift the tractor hood and pivot forward to open.
Remove the hex shoulder bolt and wing nut from the
negative
(black)cable.
Wing Nut
Negative
Cable
I
Shoulder B olt
Figure 3-1
Pull the protective
cap, if present, off the negative
battery terminal.
Attach the negative cable (heavy
black wire) to the negative
battery terminal
(-) with
the bolt and wing nut. See Figure 1.
The positive cable (red cable) is secured to the positive
battery terminal
(+) with a carriage bolt and hex sems
nut at the factory. Make certain that the rubber boot
covers the positive battery
terminal.
NOTE: If the battery
is put into service after the date
shown on top of battery, charge the battery as instructed
on page 20 of this manual prior to operating
the tractor.
Gasoline Fill-up
__,
ARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable
and
the vapors are explosive. Never fuel machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes, and other
sources of ignition.
NOTE: Purchase gasoline in small quantities.
Do not use
gasoline left over from the previous season, to minimize
gum deposits
in the fuel system.
This engine is certified
to operate on unleaded
gasoline. For best results, fill the fuel tank with only
clean, fresh, unleaded gasoline with a pump sticker
octane rating of 87 or higher. In countries
using the
Research method,
it should be 90 octane minimum.
Unleaded gasoline is recommended
because it leaves
less combustion
chamber deposits and reduces
harmful exhaust emissions. Leaded gasoline is not
recommended
and must not be used where exhaust
emissions are regulated.
Gasohol (up to 10% ethyl alcohol, 90% unleaded
gasoline by volume)
is an approved
fuel. Other
gasoline/alcohol
blends are not approved.
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum
of 15% MTBE by
volume) are approved
fuels. Other gasoline/ether
blends are not approved.
The gasoline tank is under the rear fender, with the fuel fill
cap located in the center of the rear fender. The fuel cap is
tethered
to the tractor to prevent its loss. Do not attempt
to remove the cap from the tractor.
IMPORTANT: Your tractor h shipped with motor oil in
the engine. However,you MUSTcheck the oil level before
operating. Refer to the engine Owner's Manual provided with
your tractor for instructions on checking the oil level
TirePressure
WARNING:
Maximum
tire pressure under any
circumstances
is 25 psi. Equal tire pressure
should be maintained
atall times.
The tires on your unit may be over-inflated
for shipping
purposes. Reduce the tire pressure before operating
the tractor. Recommended
operating
tire pressure is
approximately
10 p.s.i for the rear tires & 14 p.s.i, for the
front tires. Check sidewall of tire for maximum
p.s.i.

Publicidad

loading