Publicidad
Idiomas disponibles
Idiomas disponibles
A'I-I'ACHtNG REPLACEMENT BLADES TO THE SAW cont. (See Figs. 17 -20)
8, Place the pin (includedwith the
wrench) into the lined up holes,
Fig, 20
9, Tighten the lock nut clockwisewith
the wrench and then remove the pin
from the blades (see Fig. 20), This will
allow the blades to turn freely.
10. Carefully turn blades with your hand
to be sure they easily turn in
opposite directions.
Lock Nut
GENERAL
/_ WARNING:
To avoid accidents,ALWAYS disconnectthe tool from the
I
power source BEFORE cleaningor performingany maintenance.
All parts represent an importantpart of the doubleinsulationsystem and shouldbe
serviced only at a Sears Service Center.
Avoidusing solventswhen cleaningplasticpads. Most plasticsare susceptibleto
damage from various types of commercial solventsand may be damaged by their use.
Use clean clothsto remove dirt, carbon dust, etc.
/_ WARNING:
DO NOT at any time let brake fluids, gasoline,petroleum-based I
products,penetratingoils,etc.to come in contact with plasticparts.They contain
I
chemicalsthat can damage, weaken or destroy plastic.
It is a knownfact that electrictoolsare subjectto acceleratedwear and possible
prematurefailure when theyare used to work on fiber glassboats and sportscars,
wallboard,specklingcompoundsor plaster.The chips and grindingsfrom these
materials are highlyabrasiveto electricaltool parts, such as bearings, brushes,
commutators,etc.Consequently,it is not recommendedthat this toolbe used for
extendedwork on any fiber glass material, wallboard, spacklingcompound,or piaster.
Duringany use on these materials,it is extremelyimportantthat the tool is cleaned
frequentlyby blowingwith an air jet.
•/1\ WAR NING:
ALWAYS wear safetygogglesor safetyglasseswithside shields I
or face shieldwhen blowingdustfrom toolwhen cleaningit.Ifoperationis dusty,also
wear s dustmask.
19
Publicidad
