Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1.
Depress
clutch/brake
pedal fully and set parking
brake.
2.
Place
gearshift
lever in neutral
(N) position.
3.
Place
attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition
key to "STOP"
and remove
key.
5.
Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come
in contact
with plug.
TO REMOVE
MOWER
Mower
will
be easier
to remove
from
the
right side of tractor.
1.
Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Move
attachment
lift lever
forward
to
lower
mower
to its lowest
position.
3.
Roll belt off engine
pulley.
4.
Remove
small
retainer
spring,
and
re-
move clutch
spring
off pulley
bolt.
5.
Remove
large retainer
spring,
slide col-
lar off and
push
housing
guide
out of
bracket.
6.
Disconnect
anti-sway
bar from
chassis
bracket
by removing
retainer
spring.
7.
Disconnect
suspension
arms from
rear
deck
brackets
by
removing
retainer
springs.
8.
Disconnect
front
links from
deck by re-
moving
retainer
springs.
9.
Raise lift lever to raise suspension
arms.
Slide
mower
out from under tractor.
IMPORTANT:
If an attachment
other than the
mower
deck is to be mounted
on the tractor,
remove
the front
links and hook the clutch
spring
Into square
hole in frame.
TO INSTALL
MOWER
1.
Raise
attachment
lift lever to its highest
position.
2.
Slide mower
under tractor
with deflector
shield
to right side of tractor.
3.
Lower
lift lever to its lowest
position.
4.
Connect
front
links to mower
deck
and
secure
with retainer
springs.
5.
Connect
suspension
arms to rear deck
brackets
and
secure
with
retainer
springs.
6.
Connect
anti-sway
barto chassis
bracket
and secure with retainer
spring.
7.
Push
clutch
cable
housing
guide
into
bracket, slide collar onto guide and secure
with large retainer
spring.
8.
Place
flat washer
and clutch
spring
on
idler
pulley
bolt
and secure
with
small
retainer
spring.
9.
Make
sure beJt is inside
the belt keeper
at the idler and on both sides
of the wire
belt keeper
as shown.
10. install
belt onto engine
pulley.
IMPORTANT:
Check
belt for proper
routing
in all mower
pulley
grooves.
Small
Retainer
Spring
Wire
Belt Keeper
Clutch
Spring
Ciutch
Sprin_
Retainer
Spring
Anti-Swal
Suspension
Arms
Engine
._;
Pulley
i"
_Square
Hole
Retainer
Springs
(Both Sides)
HousJn(
Large Retainer
Spring
21
Deflector
Shieid
Publicidad
