Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate
section
in manual
unless
directed
to Sears
service
center
PROBLEM
CAUSE
CORRECTION
1.
Cutting
too much grass/too
fast.
2.
Throttle
in "CHOKE"
position.
3.
Build-up
of grass,
leaves
and trash
under
mower.
4.
Dirty air filter.
5.
Low oil level/dirty
oil.
6.
Faulty
spark
plug.
7.
Dirty fuel filter.
8.
Stale or dirty fuel.
9.
Water
in fuel.
Loss of power
Excessive
vibration
Engine
dies when
tractor
is shifted
into reverse
Engine
continues
to run when
operator
leaves
seat with
attach=
ment
clutch
engaged
Poor
cut
= uneven
10. Spark
plug wire
loose.
11. Dirty engine
air screen/fins.
12. Dirty/clogged
muffler.
13. Loose
or damaged
wiring.
14. Carburetor
out of adjustment.
15. Engine
valves
out of
adjustment.
1. Worn,
bent or loose
blade.
2.
Bent blade
mandrel.
3.
Loose/damaged
part(s).
,
,
Reverse
operation
system
(ROS)
is not "ON" while
mower
or other attachment
is engaged.
Faulty
operator-safety
presence
control
system.
,
2.
3.
4.
5.
Worn,
bent or loose
blade.
Mower
deck not level.
Buildup
of grass,
leaves,
and trash
under
mower.
Bent blade
mandrel.
Clogged
mower
deck vent
holes from
buildup
of grass,
leaves,
and trash
around
mandrels.
1.
Raise cutting
height/reduce
speed.
2.
Adjust
throttle
control.
3.
Clean
underside
of mower
housing.
4.
Clean/replace
air filter.
5.
Check
oil level/change
oil.
6.
Clean
and regap
or change
spark
plug.
7.
Replace
fuel filter.
8.
Empty fuel tank and refill tank
with fresh,
clean gasoline.
9.
Empty
fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace
fuel filter.
10. Connect
and tighten
spark
plug wire.
11. Clean
engine
air screen/fins.
12. Clean/replace
muffler.
13.Check
all wiring.
14. See "To Adjust
Carburetor"
in Service
and Adjustments
section.
15. Contact
a Sears
or other
qualified
service
center.
1.
Replace
blade.
Tighten
blade
bolt.
2.
Contact
a Sears
or other
qualified
service
center.
3.
Tighten
loose
part(s).
Replace
damaged
parts.
1. Turn ignition
key to
ROS
ON
position.
See Operation
section.
,
Check
wiring,
switches
and
connections.
If not corrected.
contact
Sears
or other
qualified
service
center.
1.
Replace
blade.
Tighten
blade
bolt.
2.
Level
mower
deck.
3.
Clean
underside
of mower
housing.
4.
Contact
a Sears
or other
qualified
service
center.
5.
Clean
around
mandrels
to
open vent holes.
28
Publicidad
