Publicidad
Idiomas disponibles
Idiomas disponibles
The operation
of any tractor
can
result in foreign
objects
thrown into the
eyes, which can result in severe eye damage.
Always
wear safety glasses
or eye shields while operating
your tractor or performing
any adjustments
or repairs.
We recommend
standard
safety glasses
or a wide vision safety
mask worn over spectacles.
HOW
TO
USE
YOUR
TRACTOR
TO SET PARKING
BRAKE
",(our tractor is equipped
with an operator
presence
sensing
switch.
When engine is
running, any attempt by the operatorto
leave
the seat withoutfirst
setting the parking brake
will shut off the engine.
1. Depress brake pedal (B) allthe way down
and hold.
2.
Pull parking brake lever (C) up and hold,
release
pressure
from brake pedal (B),
then release
parking
brake lever. Pedal
should
remain
in brake
position.
Make
sure parking brake wilt hold tractor secure.
STOPPING
MOWER
BLADES
-
" To stop mower blades,
move attachment
clutch clutch lever to disengaged
position
(r_'t) Attachment
Clutch Switch
"Engaged"
(r_l)Attachment
Clutch Switch
"Disengaged"
GROUND
DRIVE
-
° To stop ground drive, depress brake pedal
all the way down.
IMPORTANT:
Forward
and reverse
drive
pedals
return
to neutral
position
when
not
depressed.
ENGINE
-
o Move throttle
control (D) between
half and
full speed
(fast) position.
NOTE:
Failure
to move throttle
control be-
tween half and full speed (fast) position,
be-
fore stopping,
may cause engine to "backfire".
, Turn ignltion
key (F) to "STOP"
position
and remove key_ Always remove keywhen
leaving tractor to prevent unauthorized
use.
° Never use choke (N) to stop engine.
IMPORTANT:
Leaving
the ignition switch in
any position
other
than "STOP"
will cause
the battery
to discharge
and go dead°
NOTE: Undercertain
conditionswhentractor
is standing
idle with the engine running,
hot
engine
exhaust
gases
may cause "brown-
ing" of grass.
To eliminate
this possibility,
always
stop engine
when
stopping
tractor
on grass areas_
_CAUTION:
Always
stop tractor
com-
pletely, as described
above,
before leaving
the operator's
position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast)°
o Operating engine at less than full speed
(fast)reduces engine'soperatingefficiency,
° Full speed (fast) offers the best mower
performance.
TO USE CHOKE
CONTROL
(N)
Use choke control whenever
you are starting
a cold engine.
Do not use to start a warm
engine.
° To engage
choke
control,
pull knob out.
Slowly push knob in to disengage.
15
Publicidad
