Publicidad
Idiomas disponibles
Idiomas disponibles
_
ARNING:
TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR
ADJUSTMENTS:
and set
3
Depress
clutch/brake
pedal fully
parking
brake.
o Place attachment
clutch
in "DISENGAGED"
position°
4.
Turn ignition
key to "STOP"
and remove
key.
5o Make sure the blades and all moving
parts have completely
stopped.
6. Disconnect
spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TO REMOVE
MOWER
1. Place attachment
clutch
in "DISEN-
GAGED"
position.
2o Lower
attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from lock
bracket
(L)_
CAUTION:
Belt tension
rod is spring
loaded° Have a tight grip on rod and release
slowly°
4.
Remove
mower
belt from electric
clutch
pulley (M).
5.
Disconnect
front link (E) from mower
remove
retainer
spring and washer.
6.
Go to either side of mower and disconnect
mower
suspension
arm (A) from chas-
sis and rear lift link (C) from rear mower
bracket
(D) - remove retainer springs and
washers.
7.
Go to other side of mower and disconnect
the suspension
arm and rear lift link.
CAUTION:
After rear lift links are discon-
nected, the attachment
lift lever will be spring
loaded.
Have a tight grip on lift lever when
changing
position
of the lever.
8.
From
right side
of mower,
disconnect
anti-sway
bar (S) from right rear mower
bracket
(D) - remove retainer spring and
washer and pull mower toward you until
the bar fails from the hole in bracket.
9.
Turn tractor
steering
wheel to the left as
far as it will go.
10.Slide
mower out from under right side of
tractor.
TO INSTALL MOWER
Follow procedure described
in "INSTALL
MOWER AND DRIVE BELT"intheAssembly
section of this manual.
26
Publicidad
