cecotec IRONHERO 3200 FORCE ANODIZED Manual De Instrucciones página 37

3. OPERATION
Filling up the water tank
1. Make sure the iron is switched off and unplugged before filling up the water tank.
2. Turn the steam knob to the 'MIN' position before filling up the water tank.
3. Place the iron on a stand, tilt it forward at an angle of approximately 45 degrees and pour
water through the filler opening into the MAX position of the water tank.
4. Empty the water tank after each use.
5. Pour out the remaining water after use.
Vertical steaming
The "steam burst" can also be applied when the iron is held vertically, which is useful for
removing wrinkles from hanging clothes, curtains, etc.
Dry ironing
1. Place the steam knob in the O position (that is, no steam.)
2. According to the care label of the different garments, set the correct ironing temperature
to start ironing.
Steam ironing
1. Fill up the iron as explained in section: "Filling up the water tank."
2. Plug the appliance into the main socket.
3. Set the temperature/thermostat selector to MAX position according to the temperature/
thermostat knob for steam ironing, otherwise water may come out of the soleplate.
4. When the indicator light goes out, it means that the right temperature for ironing has been
reached.
5. Set the steam switch correctly. To increase the steam, turn the switch counterclockwise
and to decrease the steam turn the switch clockwise.
Steam burst
This function is suitable for difficult creases and thick fabrics. When you press the "Steam
Burst" button, the soleplate emits an intense burst of steam, which is very useful for removing
stubborn creases. The steam function can only be used when ironing at a high ironing
temperature. For optimal results, there should be a 5 second rest period between pressing the
steam button. To avoid water leakage through the soleplate, do not press the steam button
continuously for more than 5 seconds. In addition, you should allow an interval of at least one
minute before using the steam burst function.
Spraying methods
By pressing the spray button a couple of times, garments can be dampened at any temperature.
Make sure there's enough water in the tank.
IRONHERO 3200 FORCE ANODIZED
ENGLISH
37