THOMSON ANT1703BK Instrucciones De Uso página 5

5. Wall Mountin
Я Note - headphone holder function
Bang You can also use the wall holder to store the
+ Buy special or suitable installation material from a headphones. By storing the headphones using the
specialised dealer for wall-mounting. headband, the earpads are protected and remain free of
Ё pressure marks (see ріс. 6).
• Ensure that you do not use faulty or damaged parts
or installation.
+ Use the product for its intended purpose only.
| ©
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
e Never apply force during mounting. This could and do not use aggressive cleaning agents.
damage the antenna or the bracket.
+ [fin doubt, have this product mounted by a qualified 8. Warranty Disclaimer
echnician - do not attempt to mount it yourself! Hama GmbH & Co. KG assumes no liability and provides no
+ Do not mount the product above locations where warranty for damage resulting from improper installation/
persons might linger. mounting, improper use of the product or from failure to
й CR. observe the operating instructions and/or safety notes.
+ After mounting the antenna, check that it is P 9 у
sufficiently secure. You should repeat this check at 9. Service and Support
regular intervals. Remove the antenna if the bracket
i questions about this product.
• Before mounting the bracket, ensure that the chosen Hotline: +49 9091 502-115 (German/English)
wall is suitable for the weight to be mounted, and Further support information can be found here:
make sure that no electrical wires, water, gas or other www.hama.com
lines are present at the mounting point on the wall.
e Attach the anchor and screw to the chosen wall (pic. 2). 10. Technical Data
@ e Clip the antenna/headphone holder into the opening
provided for this purpose (pic. 3) Connection IEC plug (Coax plug)
6. Operation Max. amplification 46 dB
* Connect the enclosed power supply unit to the DC IN port
on the underside of the antenna and to a 230 V socket.
* Connect the antenna cable (8) to the antenna port on
your TV (pic. 4).
* If you are using an external DVB-T receiver, connect the
antenna cable (8) to the DVB-T receiver (pic. 5).
* To get perfect reception, pull out the two telescopes (7)
completely.
Switch on the antenna by turning the control dial (5) in
he Max direction until it clicks and the status LED (6)
ights up.
e Adjust the antenna for the best possible reception.
Depending on horizontal or vertical polarisation in the
UHF band, the telescopes (7) can be readjusted.
Depending on the station, adjust the amplifier by turning
he control dial (5) in the Max or Min direction.
e Switch off the antenna if it is not required.
Please note that the number and quality of stations
received may depend on the position of the antenna and
on the local conditions.
Coaxial cable length 1.5 m
Power cable length 1.8m
External power supply unit/
; 6 V, 100 mA/remotely fed
Frequency range 30-790 MHz (FM, VHF, UHF)
Technology DVB-T/DVB-T2
Indoor antenna/
purpose Headphone holder
00131918man cs de el en es fi fr hu it nl pl pt ro ru sk sv tr.indd 29.11.13 12:21