Chasing PING 360 Manual De Usuario página 5

3. Replace with a new connection cable. Check the O-ring before mounting,
screw it to the remaining 2-3mm space, connect the 4P leadwire to the
"ETHERNET", and connect the 2P leadwire to the "POWER";
EN
2
4P communication cable (Orange Green)
1
2P power cord (reddish black)
4. Align the gap, close the Ping360 main body, mount the limit rope, and tighten
the connection cable interface with a spanner;
Close the Ping360 main body
5. Perform the steps from "III. Mounting and Connection of CHASING M2 PRO
MAX" to Step 4 above, turn on the computer, and connect the Wi-Fi of the
CHASING yellow remote controller RC3. Open the Ping-Viewer app on the PC -
click (Icon Settings) - Static IP - IP address: 192.168.1.107, and change the IP
address to 192.168.1.107 to save.
05
2
1
Mount the limit rope Tighten the interface
with a spanner
Note
1. If CHASING Ping360 is applied together with the CHASING waterproof remote
controller with screen, please connect the computer and the waterproof
remote controller with screen with a network cable and configure the static IP
address of the computer, as shown in the figure below. (after using the sonar,
please remember to change back to "automatically obtain IP address" on the
computer)
1
Click
2
Double click
5
2. If it still cannot be used after performing above steps, try to connect a patch
panel inside (gift). For specific operating steps, please scan the QR code on the
"Teaching Card" to check the "Patch panel mounting" section of the
"Connection cable replacement tutorial of CHASING Ping360 sonar".
3
Fill as in the figure
4
Click
Click
EN
06